LOC Ultimate Build Pictures

Warning: The large version of the images are ... well, large (1.3+MB). I recommend not clicking unless your dying for a very, very large version of the picture.

I'm planning on extending the payload tube by 13 inches or so, and using my 3.9" electronics bay to for dual deployment.

First flight will be on a 29mm Aerotech G or H. Future clustered flights will be on 29mm single use EX motors (Wimpy Red). Probably start with 3 and work up to the full 7.

Back side of the top centering ring.
A fuzzy view of the front side of the top centering ring.
Another fuzzy view of the front side of the top centering ring.
A clear view of the front side of the top centering ring. The holes are too close together. The outside motor tubes are pinched.
The motor mount together without glue. I wish I knew then what I know now.
The motor mount together with the first application of epoxy (the tape is there just to hold things in place). I noticed about 10 minutes after taking this picture (and putting about three more applications of epoxy) that the rear centering ring is too far forward. I'm going to have to notch the fins to fit over it.

Return to David's Home Page.
Return to David's Rocketry Home Page.
Return to Cayuga's Home Page.

Valid HTML 3.2!